Small Heat Exchanger Unit

The clamping dimensions are not in place, the dimensions are uneven, or the clamping bolts are loose;The solution is to re-clamp the equipment, ensuring the dimensions are uniform.The deviation of the clamping dimension should not exceed ±0.2N.The parallelism between the two clamping plates should be kept within 2mm.

Part of the gasket has detached from the sealing groove, and there is dirt on the main sealing surface of the gasket.Damaged gaskets or aging gaskets in plate heat exchangers;The solution to this problem is,Mark the external leakage points and disassemble the small heat exchange unit.Troubleshoot and resolve issues one by one, and reassemble or replace gaskets and plates.

Deformation of the panels and misalignment during assembly caused the mat to shift; the solution is very simple.This involves repairing or replacing deformed parts of the sheet.

Cracks are present in the plate sealing groove or the secondary sealing area;The corresponding solution is to reassemble the plates.The board surface should be cleaned to prevent dirt from adhering to the gasket sealing surface.