Product Introduction：
Industrial heat exchange units are easy to operate and install.When installing industrial heat exchange units,Some degree of positional deviation is inevitable.However, this deviation still needs to be controlled within a certain range.For the bolts installed on various components of industrial heat exchange units,Make sure to tighten it thoroughly. When tightening, it can be done in three passes, with each pass's endpoint staggered by 120°.
Features：
The hoisting process demands a high level of technical expertise.Make sure to do a good job of preliminary preparation.Industrial heat exchange units have large diameters, numerous heat exchange tubes, and heavy lifting capacity.When lifting and securing, pads should be added to the shell supports.Wooden blocks are placed on both sides of the casing of the industrial heat exchanger unit to protect the casing.To prevent the shell from being crushed, deformed, or damaged by the wire rope during lifting.A sliding plate should be pre-embedded on one side of the movable support on the foundation, and there should be shims on both sides of the anchor bolts.Before leveling, the inclined shims can be welded firmly to the base plate of the industrial heat exchanger unit.However, it cannot be welded to the flat pad or sliding plate, and the pad needs to be lubricated and flat to ensure that the movable support can extend and retract freely.
Product Certification：
workshop：
Application Scope：
If you want to know more about heat exchanger units or are interested in purchasing, please send an email to 9988xiaoshuai@gmail.com, we will reply you in time after seeing the message!
Hot Tags: industrial heat exchanger units, China industrial heat exchanger units manufacturers, suppliers, factory, complete heat exchanger unit, Efficient Heat Exchange Unit, Fully Automatic Heat Exchanger Unit, heat exchange unit, Heating Heat Exchanger Unit, Water water Heat Exchanger Unit
